![]() ![]() If you are using the windows HyperTerminal, select "Transfer">"Send File" and specify the recovery image file in the Filename field, and select the 1K Xmodem from the Protocol field. (You can find the recovery image file from the firmware package, the extension file name is. Step 5: When the message "Starting XMODEM upload (CRC mode)" appears, select the recovery image file to upload to ZyWALL with 1K Xmodem protocol. Step 4: Enter "Y" and wait for the "Starting XMODEM upload" message before activating XMODEM upload on your terminal. Step 3: Enter the command below to initialize the recovery process. ![]() Step 2: Press any key when you see the message "Press any key to enter debug mode within 3 seconds" to enter debug mode. Step 1: Use a console cable and connect to the ZyWALL. Use the steps below if your device has stopped responding for an extended period of time and you cannot access or ping it. This section describes how the ZyWALL notifies you of a damaged recovery image or firmware file. The ZyWALL's recovery image and/or firmware could be damaged, for example, by the power going off during a firmware upgrade. ![]() Error message "Invalid Recovery Image" appears on the console while ZyWALL is starting up.
0 Comments
Leave a Reply. |